eDIN #1004 Demultiplexer (DMX to Analog)

The eDIN #1004 converts DMX512 to 16 channels of analog DC output voltage.  Diode shunts allow user-selection between current sourcing applications — typically for theatrical dimmers — or current-sinking control — typically for LED fixture drivers or Mark VII electronic fluorescent ballast control.  A non-dim mode supports solid-state relay control.

• One DMX512-A/RDM data input connection
• One passive DMX512-A data through connection
• Standard DC output modes of 0-10V, 0-15V, 0-2.5V, or 0-5V
• Custom mode allows user-set minimum and maximum DC output up to 16V
• EFBC/LED Driver mode allows single DMX channel control of mains voltage (via SSR) and 0-10V dimming
• Maximum current rating per output of 10mA (sourcing) or 30mA (sinking)
• CCL "Panic Input" drives all outputs to full
• Pluggable terminal block connections accept solid or stranded wire between #26 and #16 AWG
• Power and data easily daisy-chained between modules
• Termination switch
• 6.25" long
• 6W power consumption
• Does not include power supply, requires 9-30 VDC PSU.
• Pathway has determined that some LED manufacturers are providing non-isolated fixture drivers with non-Class 2, 0-10V dimming options.  The #1004 is not intended for use with non-isolated or Class 1 fixture drivers.  Please review the Technical Bulletin in the download tab, or download the document here.  Use of the #1004 with non-isolated drivers may result in damage to the #1004.  This damage is not covered under warranty.